The dbx1066 is the Stereo Compressor/Limiter/Gate of the 90's. After producing the world's most renown series of compressors, the task of producing a new compressor worthy of our reputation would be daunting for most engineers. Not for dbx. Our engineers know audio like no one else in the world. Now the fruits of their talents are available to you in the form of the 1066 Stereo Compressor/Limiter/Gate. |
Connectors: | XLR and 1/4" TRS (Pin 2 and tip hot) |
Type: | Electronically balanced/unbalanced, RF filtered |
Impedance: | Balanced > 50 kOhm, unbalanced > 25 kOhm |
Max Input Level: | > +24 dBu balanced or unbalanced |
CMRR: | Typically > 50 dB at 1 kHz |
Connectors: | XLR and 1/4" TRS (Pin 2 and tip hot) |
Type: | Servo-balanced/unbalanced, RF filtered |
Impedance: | Balanced 120 Ohm, unbalanced 60 Ohm |
Max Output Level: | > +21 dBu, > +20 dBm |
Connector: | 1/4" TS |
Type: | Unbalanced, RF filtered |
Impedance: | > 10 kOhm |
Max Input Level: | > +24 dBu |
Connector: | 1/4" TRS (tip hot) |
Type: | Impedance balanced, RF filtered |
Impedance: | Balanced 2 kOhm, unbalanced 1 kOhm |
Max Output Level: | > +21 dBu balanced or unbalanced |
Bandwidth: | 20 Hz to 20 kHz, +0/0.5 dB |
Frequency Response: | 0.35 Hz to 90 kHz, +0/-3 dB |
Noise: | < -96 dBu, unweighted, 22 kHz measurement bandwidth |
Dynamic Range: | > 118 dB, unweighted |
THD+Noise: | 0.008% typical at +4 dBu, 1 kHz, unity gain |
| 0.08% typical at +20 dBu, 1 kHz, unity gain |
| < 0.1%, any amount of compression up to 40 dB, 1 kHz |
IMD: | < 0.1% SMPTE |
Interchannel Crosstalk: | < -80 dB, 20 Hz to 20 kHz |
Stereo Coupling: | True RMS Power Summing |
Threshold Range: | -40 dBu to +20 dBu |
Ratio: | 1:1 to :1 |
Threshold Characteristic: | Selectable OverEasy? or hard knee |
Attack/Release Characteristic: | AutoDynamic |
Attack/Release Modes: | Selectable Manual or Auto |
Manual Attack Time: | Scalable program-dependent |
Manual Release Time: | Scalable program-dependent |
Auto Attack Time: | Program-dependent |
Auto Release Time: | Program-dependent |
Output Gain: | -20 to +20 dB |
Threshold Range: | +4 dBu to +24 dBu (off) |
Ratio: | :1 |
Limiter Type: | PeakStopPlus two-stage limiter |
Stage 1: | PeakStop? brickwall limiter |
Attack Time: | Zero |
Release Time: | Zero |
Stage 2: | Predictive intelligent program limiter |
Attack Time: | Program-dependent |
Release Time: | Program-dependent |
Threshold Range: | Off to +15 dBu |
Ratio: | 1:1 to 30:1 |
Attack Time: | < 100 μsec |
Release Time: | Program-dependent |
SC Ext: | Routes the external sidechain input signal to the detector. |
SC Mon: | Routes the sidechain signal to the output, interrupting the normal audio. |
OverEasy?: | Activates the OverEasy? compression function. |
Contour: | Activates the frequency-dependent detector function. |
Auto: | Activates automatic program-dependent attack and release times, disabling the manual Attack and Release controls. |
I/O Meter: | Switches between monitoring input and output levels on the Input/Output Level meter. |
Bypass: | Activates the direct input-to-output hard-wire relay bypass. Relay automatically hard-wire bypasses unit at power-down and provides a power-on delay of 1.5 sec. |
Operating Level (rear panel): | Switches the nominal operating level between -10 dBV and +4 dBu simultaneously for both input and output levels. |
ST Link: | Links both channels for stereo operation. Channel One becomes the master. |
Gain Reduction Meter: | 12-segment LED bar graph at 1, 2, 4, 6, 9, 12, 15, 18, 21, 24, 27 and 30 dB |
Input/Output Meter: | 8-segment LED bar graph at -24, -18, -12, -6, 0, +6, +12, and +18 dBu |
Compressor Threshold Meter: | 3-segment LED bar graph at Below (-), OverEasy?. and Above (+) |
Exp/Gate Threshold Meter: | 2-segment LED bar graph at Below (-) and Above (+) |
Limiter, Thershold Meter: | 1 LED to indicate PeakStopPlus limiting |
Function Switches: | LED indicator for each front-panel switch |
Per Channel: | Jensen?JT-123-dbx or JT-11-dbx, BCI RE-123-dbx or RE-11-dbx |
Operating Voltage: | 100-120 VAC 50/60 Hz 200-240 VAC 50/60 Hz |
Power Consumption: | 20 Watts |
Fuse: | 100-120 VAC: 250 mA Slow Blow |
200-240 VAC: | 125 mA Type T |
Mains Connection: | IEC receptacle |
Dimensions: | 1.75"Hx19"Wx9"D (4.4cmx48.3cmx20.1cm) |
Weight: | 5.1 lbs (2.3 kg) |
Shipping Weight: | 7.5 lbs. (3.4 kg) |
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
상품이 장바구니에 담겼습니다.
바로 확인하시겠습니까?
상품이 찜 리스트에 담겼습니다.
바로 확인하시겠습니까?